Magnavox 19MF301B Service Manual Page 30

  • Download
  • Add to my manuals
  • Print
  • Page
    / 137
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 29
7-1 FL11.0FW
FIRMWARE RENEWAL MODE
Equipment Required
a. USB storage device
b. Remote Control Unit
Firmware Update Procedure
Note: There are two states (the User Upgrade and
the Factory Upgrade) in firmware update.
The identification of User Upgrade and Factory
Upgrade are done by the filename.
1. Turn the power off and unplug the AC Cord.
2. Insert the USB storage device to the USB port as
shown below.
TYPE A (Example: 19MF301B/F7)
TYPE B (Example: LC190SS2)
TYPE C (Example: 19ME601B/F7)
3. Plug the AC cord in the wall outlet and turn the
power on.
4. The update will start and the following will appear
on the screen.
Note: If the above screen isn’t displayed, repeat from
step 1.
The appearance shown in *1 is described as follows.
User Upgrade Upgrade the firmware only. The
setting values are not initialized.
Factory Upgrade
(Firmware upgrade)
Upgrade the firmware and
initialize the setting values.
Factory Upgrade
(Flash upgrade)
Upgrade the firmware and
initialize the setting values
along with the setting data
adjusted at the factory such as
White Balance, etc.
Rear Cabinet
USB port
USB storage
device
USB port
USB storage
device
Rear Cabinet
Appearance State
Downloading...
Downloading the firmware from
the USB storage device.
Writing...
Writing the downloaded firmware
in flash memory.
Checking... Checking the new firmware.
Rear Cabinet
USB port
USB storage
device
Software upgrade in progress. Please wait.
Do not remove the USB storage device or
turn the TV off while upgrade is in progress.
Software Upgrade
Downloading...
Current Version:
New Version:
*******-***-*-***-****
*******-***-*-***-****
0%
*1
"
*
" differs depending on the models.
Page view 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 136 137

Comments to this Manuals

No comments