Magnavox MAS-300 User Manual download pdf (Page 6)

f you cable signal uses a cable box or

decoder, follow the easy steps below to

complete the connection.

Cable Box (w/RF In/Outputs):

This connection will be mono,

Connect the Cable Company

supplied cable to the signal

IN(put) plug on the back of the

Cable Box.

Using a separate round coaxialcable, connect one end to the

OUT(put) (TO TV) plug on

the back of the Cable Box.

Connect the other end of the

round coaxial cable to the 75_

input on the back of the television.

Screw it down finger tight.

NOTE: If applicable, set the OUTPUT

CHANNEL SWITCH on the back of the

cable box to CH 3 or 4. Tune the TV to

the same channel and change channels

at the cable box. In some cases,the

cable box will automatically tune to

either channel 3 or 4, change channels

until the picture appears.

Cable Signal IN

from the Cable

Company

Round 7512

Coaxial Cable

Jack Panel Back of TV

If no Video Signal is present, the TV

will shut itself off in about I0 minutes,

If the TV is tuned to the AV channel

and there is no Video Signal present,

the screen will remain black and the

TV will shut itself off in about I0 min-

utes,

1 2 3 4 5 6 7 8 9 10 11 ... 35 36

No comments

Magnavox MAS-300 User Manual Page 6